How To Stain A Wood Table

Apply stain apply stain with a disposable brush following the wood s natural grain.

How to stain a wood table. When staining a table it s always easier to slowly stain wood furniture darker then it is to lighten. Stain only provides color not a finish. Sand with not against the grain of the wood.

Sand until the wood is smooth and even to the touch. When applying the cloth should be wet but not. After 1 hour the surface is dry to the touch.

Wipe off the sanding dust with a tack cloth. Clean the wood with mineral spirits applied with a rag or a sponge. Between sandings use a tack cloth to remove dust.

Use a rag or cloth instead of a sponge which may absorb the stain. Here is a little progression of the staining wood table from unfinished through the second coat of wood stain. Wood furniture doors woodwork cabinets accessories.

Apply the water based stain in the same way as oil based. Put on rubber gloves and. How you apply the stain onto the wood cross grain or with the grain is less important than applying plenty of it.

This will help a soft wood absorb stain more evenly. For a deeper color and sheen wait one hour and apply a second coat. Apply stain liberally allowing it to soak in for a few minutes then wipe off excess stain with a soft cotton rag synthetic rags aren t going to soak up excess stain using the rag to rub the stain into fine cracks in the wood.

After applying the conditioner wait at least 15 minutes but no more than 2. Apply the wood conditioner. Brush the stain liberally onto the table following the natural direction of the grain.

Brush on wood conditioner prior to staining. After the second coat two more coats of stain are applied to achieve a rich dark chocolate brown stain finish. On bare wood lightly sand the surface with 150 grit sandpaper to remove nicks scratches and to open up the pores.

This helps bring out color variation in the wood. Always apply a finish on top of stained wood. Furniture oils sink in and protect wood beyond the surface can be reapplied in the future and bring out rich colors in the wood without shine try teak oil for denser woods or tung or.

Or if time is short reach for a product that combines both stain and finish with one coat. Allow the conditioner to dry for 15 minutes. Let the stain soak into the wood for just a few minutes before wiping it off with a clean towel.

Reapply the stain to reach the desired depth of color. Let the table dry according to the directions on the stain s packaging. Optional to help ensure uniform acceptance of the stain and finish use minwax water based pre stain wood conditioner.